Body Sensors Printed Directly on Skin at Room Temperature | Medgadget

Body Sensors Printed Directly on Skin at Room Temperature | Medgadget

Biomedical sensors typically perform their best when they’re placed in close proximity to the body. While wearables, such as wrist-worn heart rate monitors, are common these days, they are very limited by where they can be placed on the body, have poor signal quality, and are often uncomfortable to wear for extended periods. Now, researchers from Pennsylvania State University, Harbin Institute of Technology in China, and a few other Chinese institutions have developed a way to print electronic sensors, as well as the accompanying electronics, directly onto the skin without using any heat in the process. 

Sourced through Scoop.it from: www.medgadget.com

Who We Are

Omnica Corporation is a privately-held design, engineering, and medical product development firm located in Irvine, California. The 28-person company is staffed with full-time employees and has been in operation since 1984. Our speciality is custom product development for the medical industry and industrial fields.

Our expertise is developing complex medical devices.Technical personnel at Omnica includes designers, mechanical engineers, electronic and software engineers, advanced R&D specialists, regulatory staff (for FDA documentation), machinists and model makers.

Learn MoreOmnica Corporation

Leave a Reply

Your email address will not be published. Required fields are marked *